D. Align the “V” notch at the center line of the support box with box location marked on stud. Attach box support to stud using two self-tapping screws.
Do not over-torque
TECHNICAL SUPPORT: 800-943-9771
You Will Need These Tools
Do Not Feed Romex (Non-Metallic Sheathed Cables) Through Hole in Support Leg of Box Support
- AMSI products shall be installed and used only as indicated in AMSI product installation materials. Instructions sheets are available no charge HERE and from your AMSI customer service representative or by calling 1-800-943-9771.
- AMSI products must never be used for purpose other than that for which they were designed.
- All AMSI instructions must be followed completely to ensure a safe and proper installation and meet all performance requirements.
- Improper or intentional installation, misuse, misapplication or other failure to completely follow AMSI’s instructions and warnings may cause the product to malfunction, may cause property damage, and may cause serious bodily injury and death.
The customer must observe all local, state, national and international governing codes required for job site safety. Always remember to wear appropriate safety equipment, such as eye protection, hard hat, gloves and fall protection as the job requires.
The customer is responsible for conformance to all local, state, national, and international governing codes.
AMSI, “H” SERIES FASTENER, QUICK-MOUNT, H4, H6, HS3, H23, are Trademarks of Architectural Metal Specialties, Inc.