Clicky

S5H90 Clamps | AMSI Supply

S5H90 Clamps

s5h90_s5h90mini

S5H90 and S5H90 mini Clamps

The S-5-H90 is a one-piece clamp that was developed to securely and cost-effectively accommodate metal roof panels with a horizontal seam greater than 0.65″.

Turning the clamp 90 degrees so that the bolt hole side is facing up, slip the clamp on the seam and tighten the setscrews.

After the clamp is installed, affix ancillary items using either of the two threaded bolt holes and bolt provided. The S-5-H90 is perfect for use with the
S-5! ColorGard® and X-Gard™ snow retention systems and other heavy-duty applications.

The S-5-H90 clamp has been tested for load-to-failure results on a variety of horizontal standing seam roof profiles from leading panel manufacturers. To view test data, click here. Note: This link will take you to S-5!’s website.

S5H90

S-5-H90


The S-5-H90 is perfect for S-5!® snow retention products and other heavy-duty applications. The strength of the S-5-H90 clamp is in its simple design. The patented setscrews will slightly dimple the metal seam material but will not puncture it­—leaving roof manufacturers’ warranties intact.

S-5-H90 clamps are each furnished with the hardware shown above. Each box also includes a bit tip for tightening setscrews using an electric screw gun. A structural aluminum attachment clamp, the S-5-H90 is compatible with most common metal roofing materials excluding copper. All included hardware is stainless steel.

S5H90 mini

Call for Info and Pricing

S-5-H90Mini


The S-5-H90 Mini is a bit shorter than the S-5-H90 and has one setscrew and one threaded bolt hole rather than two. The mini is the choice for attaching all kinds of rooftop accessories: signs, walkways, satellite dishes, antennas, rooftop lighting, lightning protection systems, solar arrays, exhaust stack bracing, conduit, condensate lines, mechanical equipment—just about anything!*

*S-5!® mini clamps are not compatible with, and should not be used with, S-5! SnoRail™/SnoFence™ or ColorGard® snow retention systems.

Installation

Turning the clamp 90 degrees so that the bolt hole side is facing up, slip the clamp on the seam and tighten the setscrew.

After the clamp is installed, affix ancillary items using either of the two threaded bolt holes and bolt provided. The mini is the choice for attaching all kinds of rooftop accessories: signs, walkways, satellite dishes, antennas, rooftop lighting, lightning protection systems, solar arrays, exhaust stack bracing, conduit, condensate lines, mechanical equipment—just about anything!*

The strength of the S-5-H90 clamp is in its simple design. The patented setscrews will slightly dimple the metal seam material but will not puncture it­—leaving roof manufacturers’ warranties intact.

S5H90-installSteps

Please note: The above image illustrates the S-5-H90. The steps remain the same for the S-5-H90 Mini; however, there will only be one setscrew on the clamp.

Downloads

Product Brochure

adobePDFicon